On-site checks for heat, controls, and safety — with clear findings and recommended fix steps.
Cooling performance checked, controls reviewed, and recommendations confirmed for the next step.
We verified each heating zone, checked the control panel, and confirmed stable performance before wrapping up in a Katy home.
We tested bake & broil operation, reviewed the controls, and confirmed stable heating before closing the job.
Burners were tested one by one, oven modes were cycled (bake/broil), and the controls were checked for consistent response and steady heat.
Dispenser area was opened for diagnostics — wiring, switches, and the chute were checked, connections secured, and operation verified before reassembly.
Access panel opened, leak source addressed at the bottom section, connections tightened, and the unit was run through a test cycle to confirm a dry, stable finish.
Rollers stopped turning during service — drive assembly was serviced and the unit was put back into steady rotation and heat.
Condenser coils were packed with lint — a full coil clean restored airflow and brought the system back to stable, efficient cooling.
The unit stopped holding temperature — it was pulled out, the condenser side was serviced, airflow restored, and cooling performance verified before reinstall.
The evaporator was packed in ice and airflow was полностью blocked — ice was cleared, the defrost side was restored, and cooling/ice production was verified after reassembly.
Water was leaking during the cycle — the lower section was opened, the leak source corrected, and the unit was test-run to confirm a clean, dry finish.